1. Stop engine, and remove key from ignition.
2. Grease the bearing groove (A) on the inner yokes.
NOTE:
Use High Temperature Extreme Pressure
(EP2) Performance with 1% Max Molybdenum
Disulphide (NLGI Grade 2) Lithium Base unless
otherwise speci
fi
ed.
3. Fit shield support (B) to the bearing groove (A), and
ensure that grease
fi
tting (C) faces the drive tube.
Figure 4.191: Inner Yoke and Shield Support
4. Install shield support (A) into outer cone (B), and
ensure that grease
fi
tting (C) is inserted into the
proper hole.
Figure 4.192: Shield Support and Outer Cone
5. Attach the base cone (A) and shield tube (B) to the
outer cone (C).
Figure 4.193: Base Cone, Shield Tube, and
Outer Cone
169820
206
Revision A
