8. Use a pin punch and hammer to install one shear
pin (A) so that the outermost end is
fl
ush with hub
landing (B).
IMPORTANT:
Proper shear pin orientation during installation
is critical. Shear pin grooves must be facing
the same direction and oriented on a horizontal
plane parallel to the cutterbar.
9. Repeat procedure for opposite side.
Figure 4.150: Shear Pin Orientation
10. Install two M10 bolts (A) and washers. Torque to
40 ft
·
lbf (55 N
·
m).
NOTE:
Inspect bolt threads and replace if damaged.
Figure 4.151: Cutterbar Spindle
11. Install disc assemblies onto cutterbar as follows:
•
Cutterbar Disc
(A): Refer to
•
Driven Rotary Deflector
(B): Refer to
Driven Rotary Deflectors and Driveline, page 177
•
Non-Driven
Rotary
Deflector
(C): Refer to
Installing Non-Driven Rotary Deflectors, page 182
Figure 4.152: Cutterbar Disc Assemblies
169820
188
Revision A
