4. Slide driveline shield cone away from gearbox.
5. Loosen nut (A) and use a hammer to release yoke from
taper pin lock.
6. Pull driveline off gearbox.
7. Remove driveline guard if necessary.
Refer to
Removing Driveline Guard, page 204
.
Figure 4.156: Bolt Securing Driveline
to Gearbox
Installing Primary Driveline
1. Install driveline guard onto driveline (if previously
removed). Refer to
Installing Driveline Guard, page
.
2. Position driveline as shown, and orient tapered pin so
groove of pin lines up with groove of shaft. Torque to
110 ft
·
lbf (149 N
·
m).
Figure 4.157: Bolt Installed in Yoke
3. Slide shield cone towards the gearbox, and securely
fasten two lever clamps (A) to the metal plate.
Figure 4.158: Shield Clipped to Driveline
169820
191
Revision A
