Lantech LGS-2816C-RPS, User Manual

Page: 53 / 248

C
ONFIGURING
P
ORT
S
TATUS
The function Port Status gathers the information of all ports‘ current
status and reports it by the order of port number, media, link status,
port state, Auto-Negotiation status, speed/duplex, Rx Pause and Tx
Pause. An extra media type information for the module ports1 to 8 is
also offered
.
W
EB
I
NTERFACE
To configure Port Configuration in the web interface:
1.
Click Port, Status.
2.
Display the Port status.
Figure 4-11: Port Status
P
ARAMETERS
These parameters are displayed on the Port Status page:

Port – Display the port number. The number is 1 – 24. Both port 1 ~
8 are optional modules.

Link - Show that if the link on the port is active or not. If the link is
connected to a working-well device, the Link will show the link ―Up‖;
otherwise, it will show ―Down‖. This is determined by the hardware
on both devices of the connection.
No default value.

Speed/ Duplex Mode – It shows the speed and duplex mode of all
port. The local port has to be preset its capability.
Default: None,
depnds on the result of the negotiation.

Flow Control – It shows each port‘s flow control status. There are
two types of flow control in Ethernet, Backpressure for half-duplex
operation and Pause flow control (IEEE802.3x) for full-duplex
operation. The switch supports both of them. Default: None, depends
on the result of the negotiation.