Lantech LGS-2816C-RPS, User Manual

Page: 120 / 248

–
138 –
C
HAPTER
4
| Configuring the Switch
Configure SNMP
to the DMAC address; Default: Any)

IP/Ethernet Length - Specifies whether frames can be matched
according to their ARP/RARP hardware address length (HLN) and
protocol address length (PLN) settings. (Options: Any - any value is
allowed, 0 - ARP/RARP frames where the HLN is equal to Ethernet
(0x06) and the (PLN) is equal to IPv4 (0x04) must not match this
entry, 1 - ARP/RARP frames where the HLN is equal to Ethernet
(0x06) and the (PLN) is equal to IPv4 (0x04) must match this entry;
Default: Any)

IP - Specifies whether frames can be matched according to their
ARP/RARP hardware address space (HRD) settings. (Options: Any -
any value is allowed, 0 - ARP/RARP frames where the HRD is equal to
Ethernet (1) must not match this entry, 1 - ARP/RARP frames where
the HRD is equal to Ethernet (1) must match this entry; Default: Any)

Ethernet - Specifies whether frames can be matched according to
their ARP/RARP protocol address space (PRO) settings.
(Options: Any - any value is allowed, 0 - ARP/RARP frames where the
PRO is equal to IP (0x800) must not match this entry, 1 - ARP/ RARP
frames where the PRO is equal to IP (0x800) must match this entry;
Default: Any)

IPv4:
MAC Parameters

DMAC Filter - The type of destination MAC address. (Options: Any,
MC - multicast, BC - broadcast, UC - unicast; Default: Any)
IP Parameters

IP Protocol Filter - Specifies the IP protocol to filter for this rule.
(Options: Any, ICMP, UDP, TCP, Other; Default: Any)
The following additional fields are displayed when these protocol
filters are selected.
ICMP Parameters

ICMP Type Filter - Specifies the type of ICMP packet to filter for
this rule. (Options: Any, Specific: 0-255; Default: Any)

ICMP Code Filter - Specifies the ICMP code of an ICMP packet to
filter for this rule. (Options: Any, Specific (0-255);Default: Any)
UDP Parameters

Source Port Filter - Specifies the UDP source filter for this rule.
(Options: Any, Specific (0-65535), Range (0-65535);Default: Any)

Dest. Port Filter - Specifies the UDP destination filter for this rule.
(Options: Any, Specific (0-65535), Range (0-65535); Default: Any)