Lantech LGS-2816C-RPS, User Manual

Page: 193 / 248

P
ARAMETERS
These parameters are displayed on the LLDP State page:

Tx Interval - Configures the periodic transmit interval for LLDP
advertisements. (Range: 5-32768 seconds; Default: 30 seconds)

Tx Hold - The specifies the amount of time the receiving device holds
a Link Layer Discovery Protocol (LLDP) packet before discarding it.
(Range: 2-10 times; Default: 4 times)
TTL (time-to-live) = Tx Interval * Tx Hold = 30 * 4 = 120(seconds)

Tx Delay - The specifies the delay between successive LLDP frame
transmissions. initiated by value/status changes in the LLDP local
systems MIB. (Range: 1-8192 seconds; Default: 2 seconds)

Tx Reinit - The specifies the minimum time an LLDP port waits
before reinitializing LLDP transmission. (Range: 1-10 seconds; Default:
2 seconds).

Notification Interval – The minimum interval for LLDP data change
Notification fpr the same neighbor. Refer to IEEE 802.1AB-2005 or
later for more information. (Range: 5-3600 seconds; Default: 5 secs).

Port - Port identifier. (Range: 1-24)

Mode - To enable or disable the LLDP mode per port. There are four
type. (Options: Disabled, Tx_Rx, Tx only and Rx only; Default:
Disabled)

Notification - Enables or disables each port for sending notification
to contigured SNMP trap receiver if an LLDP data change is detected
in an advertisement received on the port from LLDP neighbor.
(Default: Disabled)
Optional TLVs - Configures the information included in the TLV field of advertised
messages .

Port Descr - To evoke the outbound LLDP advertisements, includes
an alphanumeric string describing the port.

Sys Name –To evoke the outbound LLDP advertisements, includes
the system‘s assigned name

Sys Descr - To evoke outbound LLDP advertisements, includes an
alphanumeric string describing the full name and version identification
for the system‘s hardware type.

Sys Capa - To evoke outbound advertisements, includes a bitmask of
system capabilities (device functions) that are supported. Also
includes information on whether the capabilities are enabled.

Mgmt Addr - To evoke outbound advertisements, includes
information on management address.