Lantech LGS-2816C-RPS, User Manual

Page: 20 / 248

N
OTE
:
An IPv4 address for this switch is 192.168.1.1 default .
A
SSIGNING AN
IP
V
4 A
DDRESS
Before you can assign an IP address to the switch, you must obtain
the following information from your network administrator:
▼
IP address for the switch
▼
Network mask for this network
▼
Default gateway for the network
To assign an IPv4 address to the switch, type
―set ip ip mask gateway ‖
where ― ip ‖ is the switch‘s IP address, ― mask ‖ is the mask for the network
portion of the address, ― gateway ‖ is the IP address of the default
gateway, Press <Enter>.
Managed Switch - LGS-
2816C-RPS
Login: admin
Password: *****
LGS-2816C-RPS# ip
LGS-2816C-RPS(ip)# set ip ?
Usage: set <ip> [mask] [gateway]
LGS-2816C-RPS(ip)#
LGS-2816C-RPS(ip)# set ip 192.168.20.15 255.255.255.0 192.168.20.250>
D
YNAMIC
C
ONFIGURATION
O
BTAINING AN
IP
V
4 A
DDRESS
If you enable the ―dhcp‖ option, IP will be enabled but will not function
until a DHCP reply has been received. Requests will be sent periodically
in an effort to obtain IP configuration information. DHCP values can
include the IP address, subnet mask, and default gateway.
If the DHCP option is enabled, the switch will start broadcasting service
requests as soon as it is powered on.
To automatically configure the switch by communicating with DHCP
address allocation servers on the network, type the following command,
and press <Enter>. Wait a few minutes, and then check the IP
configuration settings using the ―enable dhcp‖ command.
―enable dhcp‖