Lantech LGS-2816C-RPS, User Manual

Page: 17 / 248


Set the speed/duplex mode for any port

Configure the bandwidth of any port by limiting input or output
rates or enable the Flow control of any port

Control port access through IEEE 802.1X security or static
address filtering

Filter packets using Access Control Lists (ACLs)

Configure up to 4K IEEE 802.1Q VLANs

Configure IGMP Snooping or Proxy functionality

Upgrade the system firmware or Import /Export configuration
files via HTTP (using the web interface) or TFTP (using the
command line interface)

Configure Spanning Tree/ RSTP/ MSTP parameters

Configure Class of Service (CoS) priority queuing and QoS

Configure the Port Trunk via static or LACP standard trunks

Enable port mirroring

Set storm control on any port for excessive broadcast, multicast,
or unknown unicast traffic

Display system information and statistics

Configure the LLDP Parameters
R
EQUIRED
C
ONNECTIONS
The switch provides an RS-232 serial port that enables a connection to
a PC or terminal for monitoring and configuring the switch. A null-
modem console cable is provided with the switch.
Attach a VT100-compatible terminal, or a PC running a terminal
emulation program to the switch. You can use the console cable provided
with this package, or use a null-modem cable that complies with the
wiring assignments shown in the Installation Guide.
To connect a terminal to the console port, complete the following steps:
1.
Connect the console cable to the serial port on a terminal, or a PC
running terminal emulation software, and tighten the captive
retaining screws on the DB-9 connector.
2.
Connect the other end of the cable to the RS-232 serial port on
the switch.
3.
Make sure the terminal emulation software is set as follows:
■
Select the appropriate serial port (COM port 1 or COM port 2).
■
Set the baud rates to 115200 bps.