Lantech LGS-2816C-RPS, User Manual

Page: 101 / 248

SNMP SYSTEM
CONFIGRATION
This function is used to configure SNMP settings, community name,
trap host and public traps as well as the throttle of SNMP. A SNMP
manager must pass the authentication by identifying both
community names, then it can access the MIB information of the
target device. So, both parties must have the same community
name. Once completing the setting, click < Apply > button, the
setting takes effect.
W
EB
I
NTERFACE
To configure SNMP System:
1.
Click SNMP, System.
2.
Evoke SNMP State to enable or disable the SNMP function .
3.
Specify the Engine ID
4.
Click Apply.
Figure 4-41: Set up SNMP System
P
ARAMETERS
These parameters are displayed on the SNMP System Setting page:

SNMP State – Evoke enable or disable the SNMP State. The term
SNMP here is used for the activation or de-activation of SNMP.
Default is Enable.

Engine ID – Specify the Engine ID value. SNMPv3 engine ID.
syntax: 0-9,a-f,A-F, min 5 octet, max 32 octet, fifth octet can't input
00. IF change the Engine ID that will clear all original user.