Lantech LGS-2816C-RPS, User Manual

Page: 41 / 248

S
ETTING
A
N
IP A
DDRESS
This section describes how to configure an IP interface for management
access to the switch over the network. This switch supports IP Version
4, and can be managed simultaneously through either of the address
types. You can manually configure a specific IPv4 address or direct the
switch to obtain an IPv4 address from a DHCP server when it is
powered on.
S
ETTING AN
IP
V
4
A
DDRES
S
The IPv4 address for the switch could be obtained via DHCP Server for
VLAN 1. To manually configure an address, you need to change the
switch's default settings to values that are compatible with your network.
You may also need to a establish a default gateway between the switch
and management stations that exist on another network segment.
W
EB
I
NTERFACE
To configure an IP address and SNTP in the web interface:
1 .
Click System, IP Configuration.
2 .
Specify the IPv4 settings, and enable DNS proxy service if required.
3.
Click Apply.
Figure 4-4: IP & Time Configuration
N
OTE
:
An IPv4 address for this switch could be obtained via DHCP
Server. If the switch does not receive a IP Address from a DHCP server,
it will default to the IP address 192.168.1.1 and subnet mask
255.255.255.0
You can manually configure a specific IP address, or direct the device to
obtain an address from a DHCP server. Valid IPv4 addresses consist of
four decimal numbers, 0 to 255, separated by periods. Anything other
than this format will not be accepted by the CLI program.