C
ONFIGURING
A
LARM
The function, is used to set a Alarm trap and send mail or get the Event
log. The Trap Events Configuration function is used to enable the switch
to send out the trap information while pre-defined trap events occurred.
The switch offers 24 different trap events to users for switch
management. The trap information can be sent out in two ways,
including email and trap. The message will be sent while users tick (
)
the trap event individually on the web page shown as below.
W
EB
I
NTERFACE
To display the Alarm Events Configuration:
1.
Click Alarm, Events.
2.
Evoke the Events to send email and set a trap log.
3.
Click Apply.
Figure 4-93: Display the Alarm Events Configuration
EVENTs
CONFIGURATION
To display hot to set Trap Events Configuration function is used to
enable the switch to send out the trap information while pre-
defined trap events occurred.
Summary of Contents for LGS-2816C-RPS
