Kyocera TASKalfa 306ci, Service Manual

Page: 286 / 430

2R4/2R5/2R6
6-285
Contents
Mode selection for the operation to remove overcharged toner in the developer unit (Toner apply-
ing mode). Also, sets the operation to take toner accumulated on the developer blade back to the
developer unit (vibration motor control).
Purpose
Change the setting to reduce the toner applying amount. Execute to change the vibration motor
control frequency.
* :Density is lowered if overcharged toner stays in the developer unit.
Method
1.Press the [Start] key.
2.Select the item to set.
* :The screen for setting is displayed.
Setting: Mode
1.Select the item to set.
* :Initial setting: On
2.Press the [Start] key to set the setting value.
Setting: Drum T7
1.By using the [+] [-] keys or the numeric keys, change the setting value.
2.Press the [Start] key to set the setting value.
U147 Setting the toner applying mode
(Message: Set Toner Apply Mode)
Items Contents
Mode Sets the toner applying mode.
Drum T7 Sets the toner applying width at the cleaning mode.
Developing T7 Sets the upper limit of the toner applying amount for each operation
mode.
Motor Sets the vibration motor operation.
Items Contents
On Sets the toner applying operation with the normal amount.
Off Sets the toner applying operation with less than the normal amount.
Items Contents Setting range Initial
setting
Data
varia-
tion
Value Sets the toner applying width at the
cleaning mode. 0 to 25 150
(Indicated as
15.0) 0.1mm