Kyocera TASKalfa 306ci, Service Manual

Page: 119 / 430

2R4/2R5/2R6-3
6-118
*: Cut the trailing edge of the DP adjustment original (ChartB) as shown below.
Method: Table (Chart A)
Automatic input of the target value
* :Usually, it adjusts here.
1.Set the specified original (P/N: 7505000107) on the table.
2.Enter maintenance item U411.
3.Select [Target].
4.Press the [
Ż ] [ Ź ] keys, [#] or [*] key to select [Auto].
5.Select [Table(ChartA)] using the [Up/Down cursor] key.
6.Press the [Start] key to read the barcode of the original chart and to start the automatic adjust-
ment.
7.When automatic adjustment has normally completed, [OK] is displayed.
* :When the error code "1e" or "1f" is displayed during the automatic adjustment in the table
scanning and the barcode is not read, adjust the following after manually inputting the target
value.
Manual input of the target value
1.Enter the target values which are shown on the lower part of the front page of the adjustment
original (P/N: 7505000107) by executing the maintenance mode U425.
2.Set the specified original (P/N: 7505000107) on the table.
3.Enter maintenance item U411.
4.Select [Target].
5.Press the [
Ż ] [ Ź ] keys, [#] or [*] key to select [U425].
6.Select [Table(ChartA)] using the [Up/Down cursor] key.
7.Press the [Start] key to start Auto adjustment.
8.When automatic adjustment has normally completed, [OK] is displayed.
If the image position is shifted largely at the DP adjustment below, an error might occur when
adjusting it with ChartA. First, use ChartB (image position) to adjust it and then use ChartA
(color).
Method: DP FU (Chart B)
* :Adjusting the first side of the DP duplex scanning
1.Set the specified original (P/N: 7505000106) face-up on the DP.
2.Enter maintenance item U411.
3.Select [DP FU(ChartB)].
4.Press the [Start] key to start Auto adjustment.
5.When automatic adjustment has normally completed, [OK] is displayed.
Method: DP FD (Chart B)
* :Adjusting the second side of the DP duplex scanning
1.Set the specified original (P/N: 7505000106) face-up on the DP.
2.Enter maintenance item U411.
3.Select [DP FD(ChartB)].
4.Press the [Start] key to start Auto adjustment.
5.When automatic adjustment has normally completed, [OK] is displayed.
65
80