Krone Comprima F 125, Original Operating Instructions, Page: 372 / 430

8 Terminal error messages
8.1 Faults of the electrics/electronics
90
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en
Possible cause Remedy
FMI 2: – The tailgate is open during road operating mode.
The tailgate is not locked. „
Close the tailgate using the tractor hydraulics.
The sensor is defective or has
been incorrectly set. „ Check and set the sensors B11/B12 “Lock hook bale
chamber left/Lock hook bale chamber right”,
refer to
page 73 .
522049-
Tailgate
Possible cause Remedy
FMI 2: An open tailgate was detected, although no tying has occurred since it was last closed.
The baling pressure is too
high.
„
Start net or chamber film wrapping in manual operation and
have the round bale tied,
refer to page 50 .
The bale chamber is overfilled
and it was thus opened by the
round bale.
„
Manually empty the bale chamber:
The tailgate is not correctly
locked.
„
Open and close the tailgate again.
522101-
B01
Sensor B01 “Speed of bale chamber”
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally. „
Check sensor and wiring for damage, refer to page 73 .
The sensor wiring is faulty.
522102-
B02
Sensor B02 “Tying process active”
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally.
„
Check sensor and wiring for damage, refer to page 73 .
The sensor wiring is faulty.
522105-
B05
Sensor B05 “Slip floor conveyor”
Possible cause Remedy
FMI 4: There is a cable break, cable break/short circuit, general error or undervoltage.
FMI 5: There is a cable break, general error or overload.
The sensor is damaged ex-
ternally. „ Check sensor and wiring for damage, refer to page 73 .
The sensor wiring is faulty.
522106-
B06
Sensor B06 "Twine tying cycle active"