Chapter 5 Disassembly and Assembly
5-92
6
Replace the parts.
7
See
to install the locking pin unit
assembly.
•
2 hex/Phillips-head screws (M4 x 8)
8
Close the second front door to adjust the locking
pin position.
•
Make sure that the locking lever on the second front
door is securely engaged to the locking shaft at the
position A (two of upper and lower locations). If it is
not, loosen the screws B to adjust the right and left
sides, then fix the lever.
•
B: 2 hex/Phillips-head screws (M4 x 8)
•
Make sure that the sensor dog on the second front
door is set in the almost center of the slit in the switch
mount bracket at the position C. If it is not, loosen the
screws D to adjust the up and down sides, then fix the
dog.
•
D: 2 hex/Phillips-head screws (M4 x 8)
9
Press the open/close button on the second front
door to make sure that the door can be opened
by spring force.
10
Connect the connectors removed in
and
•
PCU
•
CN1 (PCN1: cable)
•
CN2 (PCN2: cable)
•
CN3 (PCN3: cable)
•
Interlock switch cable (JJ10)
11
Install the electric component mount panel that
was removed in
•
8 hex/Phillips-head screws (M4 x 8)
12
Installation Procedures (Page 5-8)"
"5.2.3 Removing/Installing the Exterior Panel
to install the first front panel.
Now, you have finished with the procedures to replace the locking pin unit assembly.
Locking Lever
Locking Lever
Sensor
Dog
B
B
D
A
D
C
A
Summary of Contents for 0902
