Konica Minolta 0902, Service Manual

Page: 229 / 302

Chapter 5 Disassembly and Assembly
5-109
5.9.12 Replacing the Transformer
This section describes the instructions on how to replace the transformer.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
Shown below are the tools requiring to be prepared in addition to the standard tools before performing the
works in this section.
1
See " Removal Procedures (Page 5-6)" in "5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit" to remove the first front panel.
2
Remove the electric component mount panel.
•
8 hex/Phillips-head screws (M4 x 8)
Loosen all screws.
Caution
•
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
•
A transformer weighs about ??kg. When removing or installing the transformer or
transformer unit assembly, be sure to hold it securely so as not to drop it.
Personnel
Number
Work Hours (steps 2 to 9)
1
No. Tool
1 Wiring band
First Front Side