Konica Minolta 0902, Service Manual

Page: 269 / 302

Chapter 6 Adjustment
6-17
8
Confirm if it is possible to slide in the press down
adjustment jig in-between the push plate and the
shaft.
Slide in the jig along the indentation of the plate as
shown in the figure.
It is in following specified value if it is appropriate.
Go to Step 11 if you do not need to change the
Pressing Amount.
9
Change the value for the press down if the
distance between the push plate and the shaft is
not within the specified value, and reconfirm.
1. Click the [Move To HP] button.
2. Change the pressing amount.
3. Click the [Pressing Position] button.
4. Confirm if the press down adjustment jig can be
inserted again.
Repeat until the distance come within the specified value.
5
㨪
5.5mm
Second Front Side
OK: Can insert. NG: Cannot insert.
Insertion direction Status of press down
Thin Thick
OK OK Press down is weak
OK NG Appropriate
NG NG Press down is strong
Measurement Distance between the push plate
and the shaft when the press down
is performed on the 14 x 17 inch
cassette
Specified
value 5 - 5.5 mm
Note
There are around 0.15 mm error in the push
down.