Konica Minolta 0902, Service Manual

Page: 282 / 302

Chapter 7 Periodic Maintenance
7-12
7.2.8 Greasing Transporter Lead Screw Unit and Transporter Motor Unit
Assembly Gear Mechanism Unit
Apply grease to the transporter lead screw unit and the transporter motor unit assembly gear mechanism
unit.
1
Move the optical unit to the second front back
side.
2
Remove the exterior frame (back).
•
9 screws (M4 x 8)
3
Apply grease to the transporter lead screw unit
and the transporter motor unit assembly gear
mechanism unit.
•
Grease: Plusguard No. 2 by Kyodo Yushi
Apply grease on entire area by turning the transporter
lead screw by a screw driver.
4
Attach the exterior frame (back).
•
9 screws (M4 x 8)
This completes the greasing the transporter lead screw unit and the transporter motor unit assembly fear
mechanism unit.
Go to
"7.2.9 Greasing of Release Shaft Holder (Page 7-13)" and apply grease to the release shaft holder.
Caution
Be sure to turn OFF the power supply circuit breaker and unplug the power cable from the
equipment whenever the maintenance is performed.
Note
It is necessary to move the optical unit to the
second front back side when moving the push
plate unit of the transporter unit (procedure to
turn the transporter lead screw).
First Front Back Side
Transporter Lead
Screw Unit
Important
Always use the specified grease.
Transporter Motor
Unit Assembly
Gear Mechanism