Konica Minolta 0902, Service Manual

Page: 283 / 302

Chapter 7 Periodic Maintenance
7-13
7.2.9 Greasing of Release Shaft Holder
Apply grease to the release shaft holder.
1
Apply grease to the release shaft holder.
•
Grease: Plusguard No. 2 by Kyodo Yushi
This completes the greasing procedure for the release shaft holder.
Go to
"7.2.10 Greasing Justifier Motor Unit Assembly Gear Mechanism (Page 7-13)" and apply grease to
the justifier motor unit assembly gear mechanism.
7.2.10 Greasing Justifier Motor Unit Assembly Gear Mechanism
Apply grease to the justifier motor unit assembly gear mechanism unit.
1
Remove the exterior frame (front).
•
4 screws (M4 x 8)
Loosen all screws.
2
Apply grease to the justifier motor unit assembly
gear mechanism unit.
•
Grease: Plusguard No. 2 by Kyodo Yushi
Apply grease on entire area by turning A.
3
Attach the exterior frame (front) that was
removed in
Step 1 .
•
4 screws (M4 x 8)
Caution
Be sure to turn OFF the power supply circuit breaker and unplug the power cable from the
equipment whenever the maintenance is performed.
Application Point
Important
Always use the specified grease.
Caution
Be sure to turn OFF the power supply circuit breaker and unplug the power cable from the
equipment whenever the maintenance is performed.
First Front Side
A
First Front Side
Important
Always use the specified grease.