Konica Minolta 0902, Service Manual

Page: 171 / 302

Chapter 5 Disassembly and Assembly
5-51
5
Remove the receiver motor.
•
4 hex/Phillips-head screws (M4 x 8)
6
Remove the gear.
•
2 setscrews (M4 x 5)
7
Install the gear on the new receiver motor.
•
2 setscrews (M4 x 5)
When installing, make sure the clearance between the
motor main unit and the gear is 1 mm.
8
See Step 5 to install the receiver motor on the
receiver motor mount board.
•
4 hex/Phillips-head screws (M4 x 8)
9
Install the receiver motor mount board.
•
2 hex/Phillips-head screws (M4 x 8)
Press the board rightward until it reaches the dowel,
then fix it by pressing upward so as not to form any
clearance at A (between the edge of the motor and the
pulley) shown in the figure.
1mm
Important
Make sure the connector is in the right
direction when installing the motor.
A
Dowel
Dowel