Konica Minolta 0902, Service Manual

Page: 249 / 302

Chapter 5 Disassembly and Assembly
5-129
5.10.10Replacing the Back Plate Detection Unit
This section describes the instructions on how to replace the back plate detection unit.
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
The works in this section can be performed using only the standard tools.
1
See " Removal Procedures (Page 5-6)" of the "5.2.3 Removing/Installing the Exterior Panel
and Insertion Unit" , and remove the first font back panel.
2
Remove the spring from the bracket assembly on
the back plate detection unit.
3
Press the bracket assembly to lay it down.
4
Remove the back plate absorption detection
sensor.
5
Remove the back plate detection unit assembly.
•
1 screw (M4 x 8)
Caution
Be sure to turn off the power supply circuit breaker and unplug the power cable from the
equipment whenever you disassemble/assemble the equipment.
Personnel
Number
Work Hours (steps 2 to 9)
1
First Front Back Side