Konica Minolta 0902, Service Manual

Page: 178 / 302

Chapter 5 Disassembly and Assembly
5-58
6
Eject the justifier guide unit assembly.
7
Replace the parts.
Checking the Justifier Guide Unit Assembly
after Assembled
Incline the justifier guide unit assembly to make sure
that the guide can be moved by its own weight.
If it cannot, the justifier shaft has not been assembled
parallel to the guide.Adjust the justifier shaft by
tightening or loosening the setscrew.
Fixing the Cable
8
See Step 5 and Step 4 to install the justifier guide
unit assembly.
•
Belt presser plate: 1 tapping screw (M4 x 10)
•
Justifier base: 2 screws (M4 x 8)
Press the justifier guide unit assembly upward to fix it.
9
See Step 2 to install the connector (JJ18) and the
wiring band.
10
See "6.1 Adjust Justifier Belt Tension (Page 6-2)"
to adjust the belt tension.
11
See " Installation Procedures (Page 5-8)" in "5.2.3 Removing/Installing the Exterior Panel
and Insertion Unit" to install the first front panel.
Now, you have finished with the procedures to replace the justifier guide unit assembly.
Important
If the cable has been unplugged from the
justifier guide, align the white mark with the
fixing position, then fix the cable using the
wiring band.
Second Front Side
Important
Align the white mark on the cable with the
fixing position, then fix the cable using the
wiring band.