Konica Minolta 0902, Service Manual

Page: 211 / 302

Chapter 5 Disassembly and Assembly
5-91
Main Unit Side (Locking Pin Unit Assembly)
Work outline
Listed below are the number of people and the rough standard of work hours required for performing the
works described in this section.
Requirements
The works in this section can be performed using only the standard tools.
1
See " Removal Procedures (Page 5-6)" in "5.2.3 Removing/Installing the Exterior Panel and
Insertion Unit" to remove the first front panel.
2
Remove the electric component mount panel.
•
8 hex/Phillips-head screws (M4 x 8)
Loosen all screws.
3
Remove all connectors from the PCU.
•
CN1 (PCN1: cable)
•
CN2 (PCN2: cable)
•
CN3 (PCN3: cable)
4
Remove the interlock switch cable connector
(JJ10).
5
Remove the locking pin unit assembly.
•
2 hex/Phillips-head screws (M4 x 8)
Personnel
Number
Work Hours (steps 2 to 11)
1
First Front Side
JJ10
CN3
CN1
CN2
Caution
When removing the connector, hold a notch
on the connector without pulling a cable.
Giving a strong pull to the cable may cause
it to be broken.
First Front Side