234
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
22
Utility Settings
Stand-alone (Point-to-Point) Connection to a PC
The following procedure describes how to establish a point-to-point (stand alone)
connection to the oscilloscope. This is useful if you want to control the
oscilloscope using a laptop computer or a stand-alone computer.
1
Press
[Utility] > I/O
.
2
Press the
LAN Settings
softkey.
3
Press the
Config
softkey; then, turn the Entry knob to select
Automatic
, and press
the softkey again to enable it.
If your network supports DHCP or AutoIP, enabling
Automatic
lets the
oscilloscope use those services to get its LAN configuration settings
4
Connect your PC to the oscilloscope using a cross-over LAN cable such as
Keysight part number 5061-0701, available on the web at
5
Cycle power on the oscilloscope. Wait until the LAN connection is configured:
•
Press
[Utility] > I/O
and wait until the LAN status shows "configured".
This may take a few minutes.
Now, the instrument is connected, and the instrument's web interface or remote
control via LAN may be used.
File Explorer
The File Explorer lets you navigate the oscilloscope's internal file system and the
file systems of connected USB storage devices.
From the internal file system, you can load oscilloscope setup files or mask files.
From a connected USB storage device, you can load setup files, mask files, license
files, firmware update (*.cab) files, label files, etc. Also, you can delete files on a
connected USB storage device.
NOTE
The rectangular USB port on the front panel is a USB Series A receptacle to which you can
connect USB mass storage devices and printers.
The square receptacle on the rear panel labeled "DEVICE" is provided for controlling the
oscilloscope over USB. See the
Programmer's Guide
for more information.
