208
Keysight InfiniiVision 1200 X-Series and EDUX1052A/G Oscilloscopes User's Guide
19
Waveform Generator
2
In the Wave Gen menu, press the
Settings
softkey.
3
In the Wave Gen Settings menu, press the
Add Noise
softkey and turn the Entry
knob to select the amount of white noise to add to the waveform generator
output.
Note that adding noise affects edge triggering on the waveform generator source
on page 99). This is because the trigger comparator is located
after the noise source.
To add modulation to the waveform generator output
Modulation is where an original carrier signal is modified according to the
amplitude of a second modulating signal. The modulation type (AM, FM, or FSK)
specifies how the carrier signal is modified.
To enable and set up modulation for the waveform generator output:
1
If the Wave Gen menu is not currently displayed on the oscilloscope's softkeys,
press the
[Wave Gen]
key.
2
In the Wave Gen menu, press the
Settings
softkey.
3
In the Wave Gen Settings menu, press the
Modulation
softkey.
