3. Press the «DOWN» key.
The
Mode line is displayed.
6 . 1 b a r
0 8 : 1 5 A M
8 0 ° C
Header
5.1 General
Menu
·········
Pressure unit
bar
Unit of pressure
Temperature unit
°C
Unit of temperature
·········
Display lighting
Mode:
auto.¦ Timeout:
1min
Active line
4. Press «Enter».
The display for the set mode flashes.
5. Use the «Up» or «Down» keys to set the
auto. mode.
6. Press «Enter».
The setting is applied.
7. Press the «Right» arrow.
8. Set the value for the
Timeout in the same manner: 1 min, for example.
9. Press «Enter».
10. Press «Escape» repeatedly to leave this menu.
Result The display illumination is set for automatic operation with deactivation after one minute without
user intervention.
8.2.12 Setting the contrast and the brightness
Contrast and brightness are factory set to normal light conditions. You can manually set contrast
and brightness for different lighting conditions.
Precondition The operating mode is displayed.
1. Press and hold the «Information» key.
2. Use «Up» or «Down» to set the contrast.
3. Use «Left» or «Right» to set the brightness.
Result Contrast and brightness are set.
8.2.13 Activating the remote control
The «remote control» key on the operating panel of the SIGMA CONTROL 2 can be activated or
deactivated. Various menus offer check boxes for this setting.
Precondition Access level 2 is activated.
The operating mode is displayed.
1. Open the menu, e.g. 8
Communication menu.
2. Use «Up» or «Down» to select the
Key remote line.
8
Initial Start-up
8.2
Setting the controller
70
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.0.X
No.: 9_9450 12 E
