1. Open the 5.3
<Configuration – Control mode> menu.
2. Use «Up» or «Down» to select the
Local mode line.
6 . 1 b a r
0 8 : 1 5 A M
8 0 ° C
Header
5.3 Control mode
Menu
Local mode:
Active line
DUAL
------------------------------
▶1 Venting period
Venting period menu
·········
▶2 DUAL
3. Press «Down».
The currently set control mode is displayed.
4. Press «Enter».
The currently active control mode flashes.
6 . 1 b a r
0 8 : 1 5 A M
8 0 ° C
Header
5.3 Control mode
Menu
Local mode:
Active line
DUAL
------------------------------
▶1 Venting period
Venting period menu
·········
▶2 DUAL
5. Use «Up» or «Down» to set the control mode.
6. Press «Enter».
The setting is applied.
7. Press «Escape» repeatedly to leave this menu.
8.7.2 Setting the DUAL control mode
The machine switches to the READY operating point when the specified idle time has elapsed.
The shorter the period, the more often the machine will switch from IDLE to READY.
SIGMA CONTROL 2 will take into account the maximum motor switching capacity.
Depending on the machine type, the compressor motor may not fall below a minimum idling or
standstill time.
Precondition Access level 2 is activated.
The DUAL control mode is set
The operating mode is displayed
8
Initial Start-up
8.7
Control modes
106
User Manual Controller
SIGMA CONTROL 2 SCREW FLUID ≥5.0.X
No.: 9_9450 12 E
