Juniper QFX10016, Hardware Manual

Page: 251 / 439

2. Either remove the cover from the available RCB slot (see Figure 98 on page 240 ) or remove the
failing RCB (see
Removing a QFX10000 Routing and Control Board
).
Figure 98: Removing a RCB Cover Panel
3. Remove the new RCB from the electrostatic bag and inspect it for any damage before installing it
into the chassis.
4. Lift the RCB by its sides, being careful not to bump the connectors.
5. Carefully align the sides of the RCB with the guides inside the chassis.
6. Slide the RCB into the chassis, carefully ensuring that it is correctly aligned.
7. Grasp both handles and rotate them simultaneously clockwise until the RCB is fully seated and the
handles are vertical (see Figure 99 on page 240 ).
Figure 99: RCB Installation
240