Juniper QFX10016, Hardware Manual

Page: 238 / 439

7. Configure the default gateway.
[edit]
root@#
set routing-options static route default next-hop
address
8. Configure the IP address and prefix length for the switch management interface.
[edit]
root@#
set interfaces em0 unit 0 family inet address
address/prefix-length
CAUTION: Although the CLI permits you to configure two management Ethernet
interfaces within the same subnet, only one interface is usable and supported.
NOTE: The management ports, em0 (MGMT for RJ-45 connections) and em1 (also labeled
MGMT for fiber connections), are found on the port panel of the QFX10002 and on each of
the Routing and Control Boards of the QFX10008 and QFX10016.
9. (Optional) Configure the static routes to remote prefixes with access to the management port.
[edit]
root@#
set routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
10. Enable Telnet service.
[edit]
root@#
set system services telnet
NOTE: When Telnet is enabled, you cannot log in to a QFX10000 through Telnet using root
credentials. Root login is allowed only for SSH access.
11. Commit the configuration to activate it on the switch.
[edit]
root@# commit
227