Table 41: Port Mapping for Channelization
ASIC
Available Ports
Disabled Port
PE0
0, 2, 4, 6, 8
6
PE1
1, 3, 5, 7, 9
7
PE2
10, 12, 14, 16, 18
16
PE3
11, 13, 15, 17, 19
17
PE4
20, 22, 24, 26, 28
26
PE5
21, 23, 25, 27, 29
27
To change from the default mode to 40-Gigabit Ethernet channelized mode, use the Junos OS
operational command set chassis fpc
slot-number pic 0 port port number channel-speed 10g.
Network Ports
Each of the 30 QSFP28 ports supports:
• 100-Gigabit Ethernet using QSFP28 optical transceivers. When a QSFP28 transceiver is inserted into
any of the ports, the QSFP28 port is enabled for 100-Gigabit Ethernet.
• 40-Gigabit Ethernet using QSFP+ optical transceivers. When a QSFP+ transceiver is inserted into any
of the ports, the QSFP+ port is enabled for 40-Gigabit Ethernet.
• QSFP+ to SFP+ direct attach copper breakout (DACBO) cables
On the QFX10000-30C-M, the ports are enabled by default, and the default configuration adds the
ports to the default VLAN.
Power and Status LEDs
The two LEDs to the left of the network ports indicate the power (PWR) and status (STS) for the line
card. See
.
101
Summary of Contents for QFX10016
