InoTec SCAMAX H12, User Manual

Page: 123 / 136

Disruptions User Manual H12 / SCAMAX® 8x1 - Version 2019.12
Page 123 of 136
9.2.11. Paper Jam Before (2nd) Paper Output
(Error 215/216)
These errors indicate a paper jam, which occurred prior
to the paper outputs. To eliminate the respective error,
proceed according to General Paper Jam Handling ( see
chapter 9.2. ). For this, it may be necessary to open the
corresponding Output Hopper in question ( see chapter
6.2. ), so that the jammed scan material can be remo-
ved from this part of the transport area. After closing
the respective Output Hopper the scan process can be
restarted
9.2.12. Paper Jam Inside (2nd) Output Tray
(Error 217/218)
These errors indicate a paper jam that has occurred wit-
hin the designated Output Tray. These errors can only oc-
cur when the HighSpeed Stacker Arm ( see chapter 5.7.2. )
is used because due to a fault in the Highspeed Output
Mode, the Jam Sensor ( Error 217/218 ) respectively at the
Open Output Mode ( see chapter 5.7.3. ), the sensor inside
the Paper Stop ( Error 258/259 ) of the relevant Stacker
Arm has triggered. To eliminate the respective error, the
documents in the tray in question must be well arranged. Before anew Scanstart, proceed according
to General Paper Jam Handling ( see chapter 9.2. ).
9.2.13. Paper Jam Inside (2nd) Output Tray
(Error 219/220)
These errors indicate a paper jam that has occurred
within the designated Output Tray. These errors are
caused by the fact that documents in the corresponding
Output Tray have slipped under one of the lateral Paper
Guides while tray plate was lifted ( see chapter 5.7.1. ). To
eliminate the respective error, the documents in the tray
in question must be well arranged. If the error occured
while scanning, proceed according to General Paper
Jam Handling ( see chapter 9.2. ) before anew Scanstart.
9.2.14. Double Feed Detected
(Error 221)
This message appears when a double feed was detected
during the scan process and the Reaction at Detection
( see chapter 4.6.4.1.3. ) is set to Error or Transfer . In this
case, the last valid scanned document is to be deter-
mined via the Image Display or in the connected scan-
ning software. The following documents, which have
caused the double feed error, are to be put back into the
Input Tray before the scanning process is started anew.