Opening the Scanner
User Manual H12 / SCAMAX® 8x1 - Version 2019.12
6.3.
Removing/Attaching the Cover Output Hopper
The change the print position of the Imprinter Back (
see chapter
) and replace the corresponding
ink cartridge, or to open the Intermediate Drive Unit (
next chapter
), the Cover Output Hopper on the
back of the scanner must be removed first.
To remove the cover, pull the holder provided in order
to release the cover from the magnetic holders and lift
it out of the bottom-mounted suspensions. To attach,
put the suspensions back to the appropriate pins and
fold the cover upwards onto the magnetic holders.
An identical cover attached to the 2nd Output Hopper
must be usually removed only for maintenance.
6.4.
Opening/Closing the Intermediate Drive Unit
If the scanner is equipped with a 2nd Output Hopper, a short transport path is located between it and
the Output Hopper, which, in the case of a paper jam in this area, can be reached only by folding the
Intermediate Drive Unit. This is located below the Cover Output Hopper (
previous chapter
), which must
be removed beforehand.
The Intermediate Drive Unit is locked on the left and
right. To release, the locking pins must be pulled out. If
they are thereby slightly turned, they remain in the
unlocked position.
Now the Intermediate Drive Unit at the top can be fol-
ded out and thus allows you to access any jammed
documents and stuck scraps of paper, staples or the like
in this area of the transport path. To close, pull out the
two locks again, completely folding in the drive unit and
let the two latches to slide back again into the guides.
Notice
If the Intermediate Drive Unit was not closed properly, this can lead to errors in the paper
transport and to associated damage to the scanning material.
