Table 4-74
Function
Description
Enable
Enables the register function.
Server IP Address
Enter the server IP address or the server domain that you want
to register to.
Port
Enter the port of the server.
Sub Service ID
This ID is allocated by the server and used for the Device.
Step 3
Click
Apply
to complete the settings.
4.11.11 Switch Setting
This manages the internal switch setting for NVRs with built-in PoE. You can change the IP
scheme of the internal switch if necessary. The default IP scheme is 10.1.1.X. IP cameras
plugged into the built-in POE will acquire this IP scheme if the cameras are set to DHCP.
● Only models with built-in PoE ports support this function.
● Do not connect the PoE port to a switch, as this can cause connection failures.
● This function is enabled by default, and the IP segment starts from 10.1.1.1, we recommend
that you use the default setting.
● Third party IPCs are using the NVR built-in is not a supported configuration. If attempting
this, your mileage may vary.
Step 1
Select
Main Menu
>
Advanced Settings
>
Network
>
Switch
.
Figure 4-234
Step 2
Set the values of
IP Address
,
Subnet Mask,
and
Default Gateway
.
Do not set the value of
IP Address
to the same local network segment as the NVR, we
recommend that you use the default setting.
221
Summary of Contents for 1U POE NVR Series
Page 1: ...User s Manual V4 1 1 ...
Page 106: ...Figure 4 92 Figure 4 93 Step 2 Configure parameters See Table 4 26 95 ...
Page 291: ...280 ...