IC Realtime 1U POE NVR Series, User Manual, Page: 205 / 291

Parameter Description
Alarm-out Port
This will trigger an alarm device (such as lights, sirens, etc.) if one is
connected to the NVR alarm output port. .
Post-Alarm
When the alarm ends, the alarm will extend for a period of the specified
time. The time range is from 0 seconds to 300 seconds.
Show Message Check box to enable a pop-up message in your local host PC.
Report Alarm
Select the check box. when an alarm event occurs, the NVR device
uploads an alarm signal to the network (including the alarm center).
● Not all NVR models support this feature.
● you will need to set the alarm center first. For details, see
"4.12.13 Alarm Center".
Send Email
When selected, the NVR sends an Email to the set receivers when the
event is triggered.
Email settings must be configured prior. For details, see "4.12.10
Email".
Record Channel
This allows channels to record when the event occurs. Select the
check box and then select the channel(s) to be recorded.
You will need to set up the appropriate record schedule prior. For
details, see "4.1.4.6 Schedule".
PTZ Linkage
● Select the check box and click Setting to select the channel and
PTZ action. When an event occurs, the NVR will trigger the
selected PTZ action on the channel. For example, activate the PTZ
in channel one to turn to the preset point X.
● Tripwire events only support PTZ preset point activation.
● Configure the corresponding PTZ actions prior, see "4.4.4
Calling PTZ Functions".
Tour
Click to select the check box and then select the channel(s) for the
tour. When the event is triggered, the local interface of the NVR
device will display the selected channel(s) on the screen.
● It is recommended to set the interval and tour mode beforehand.
See "4.17.2 Tour".
● After the tour is over, the preview interface is restored to the screen
split mode before the tour.
194