IC Realtime 1U POE NVR Series, User Manual, Page: 148 / 291

Step 4 Configure the parameters.
Table 4-37
Parameter Description
Enable Click to set the rules as active or inactive.
Rule
Click Setting to draw areas to apply the target filter.
Each rule can set 2 target filters (maximum size and minimum
size). Targets smaller than the minimum target or larger than
the maximum target will be ignored. The maximum size should
not be smaller than the minimum size.
Schedule
This configures the days of the week and time when the rules
will be active.
Alarm-out Port
When the event is triggered, this will trigger an alarm device
(such as lights, sirens, etc.) connected to the NVR alarm
output port.
Post-Alarm
When the event ends, the alarm will extend for the specified
time. The time range is from 0 seconds to 300 seconds.
Parameter Description
Report Alarm
Select the check box. When an alarm occurs, the NVR device
uploads an alarm signal to the network (including the alarm
center).
● Not all NVR models support this feature.
● The alarm center must be configured first. For details,
see "4.12.13 Alarm Center".
Send Email
When selected, the NVR sends an Email to the set receivers
when the event is triggered.
Email settings must be configured prior. For details, see
"4.12.10 Email".
137