IBM BladeCenter S SAS RAID Controller Module, Installation And User Manual

Page: 72 / 216

<CLI> commparams –get
Ctlr0 Port0 Port1
IP ADDRESS 192.168.75.16 192.168.75.17
GATEWAY 192.168.75.1 192.168.75.1
NETMASK 255.255.255.0 255.255.255.0
VLAN tag 0d 0d
VLAN tag insert 0d 0d
Ctlr1 Port0 Port1
IP ADDRESS 192.168.75.18 192.168.75.19
GATEWAY 192.168.75.1 192.168.75.1
NETMASK 255.255.255.0 255.255.255.0
VLAN tag 0d 0d
VLAN tag insert 0d 0d
Switch Ip Address Information :
Switch Ip Address1 :
Switch Ip Address2 :
configure access
Use the configure access command to set or display configurable access protocols
(SSH and Telnet).
An error occurs if you issue the
-set
option while the list is empty.
Note: If you disable both SSH and Telnet access protocols, you must reset the
RAID controller back to the factory defaults to re-enable both access protocols. For
instructions on resetting the RAID controller, see“How to reset the SAS RAID
controllers to the factory defaults” on page 183.
Command argument:
configure access -[get | set -enable|disable [SSH|TELNET] | help]
Examples:
<CLI> configure access -get
Current Machine Local Time: 09/16/2011
04:28:38 AM
_____________________________________________
|
Access Protocol | Status |
|____________________|_______________________|
|
TELNET| ENABLED|
| SSH| ENABLED|
|____________________|_______________________|
<CLI> configure access -set -disable telnet
<CLI> configure access -get
_____________________________________________
|
Access Protocol | Status |
|____________________|_______________________|
|
TELNET| DISABLED|
| SSH| ENABLED|
|____________________|_______________________|
62
IBM SAS RAID Controller Module: Installation and User's Guide IBM BladeCenter S SAS RAID Controller Module