IBM BladeCenter S SAS RAID Controller Module, Installation And User Manual

Page: 166 / 216

6. Click Controllers .
7.
Click the controller that you are replacing.
8. From the Select a Controller Action list, select Service > Shutdown and
Recover .
9. From the Select an Action list, select Shutdown to service mode and Prepare
for removal .
10. Select the controller you are replacing.
11. Read the information that displays and click OK .
12. From the navigation panel, select BC-S SAS RAID Module > Health >
Physical View
.
13. Click Controllers .
14.
Select the
Alerts
tab.
15. Click View alert and verify alert 2101 is in the list, or verify that the amber
LED on the controller is in the SOLID state.
16. Remove the RAID Controller.
a. Open the release handle on the RAID Controller (rotate the handle up) to
disengage the RAID Controller from the bay.
b. Slide the RAID Controller out of the bay.
17. Insert the replacement RAID Controller.
a. Slide the RAID Controller into the same bay you removed the old RAID
Controller.
b.
Close the release handle (rotate the handle down).
18. Select the Properties tab and verify the controller status is Normal (Online).
19.
Ensure that no additional warnings or critical alerts are generated for the
replacement controller.
20. Connect any externally attached devices that were previously connected to
any of the four SAS ports on the RAID Controller.
21. Log into the Advanced Management Module and turn off the blue chassis
identification LED.
a. Log into the Advanced Management Module.
b. Click Monitors > LEDs > Media Tray and Rear Panel LEDs .
c.
Click
Off
next to
Location
. The blue chassis identification LED will turn
off.
Results
If the problem is not resolved, collect the logs and contact IBM.
156
IBM SAS RAID Controller Module: Installation and User's Guide IBM BladeCenter S SAS RAID Controller Module