6.
Use the arrow keys to navigate to
LUNs to Scan for Block Devices
and set it
to
[Lun 0 Only]
.
7.
Press Esc to exit the Adapter Properties screen until the utility asks you to save
the configuration as shown in Figure 20.
8.
Use the arrow keys to select
Save changes then exit this menu
, then press
Enter. The Adapter List screen displays again.
9.
Press Esc to exit the Adapter List screen. Use the arrow keys to select
Exit the
Configuration Utility and Reboot
, then press Enter.
Disabling IGMP snooping
Internet Group Management Protocol (IGMP) snooping is the process of listening
to IGMP network traffic. In a cluster configuration, you should disable IGMP
snooping to prevent node failover issues. Perform the following steps to disable
IGMP snooping.
Disabling IGMP snooping through Telnet
1.
Log into the Advanced Management Module:
a.
Enter the IP address of the Advanced Management Module into the Web
browser URL field. If you have the Advanced Management Module
connected to your network, log in using the network IP assigned to it. If
Figure 19. Advanced Device Properties screen
Figure 20. Saving configuration changes for the Onboard SAS Controller
Figure 21. Saving the BIOS setting and rebooting
46
IBM SAS RAID Controller Module: Installation and User's Guide IBM BladeCenter S SAS RAID Controller Module
Summary of Contents for BladeCenter S SAS RAID Controller Module
