IBM 866251Y - Netfinity 5500 M20, Hardware Maintenance Manual

Page: 57 / 386

1. If the PCI 1 or PCI 2 LED is on,
follow the instructions for those
LEDs.
2. If the PCI 1 or PCI 2 LED is not on,
restart the server.
If the problem persists, go to “General
checkout” on page 8. Check System
Error Log for additional information.
– PCI 1 LED on
An error occurred on PCI primary bus 0. The
adapter in PCI slot 5 or the system board
caused the error.
Actions:
1. Check the error log for additional
information. If the error log
indicates a problem with the
integrated ServeRAID controller or
the Ethernet controller, go to
“General checkout” on page 8.
2. If you cannot determine that the
adapter is failing from the
information in the error log, try to
determine if it is failing by removing
the adapter from the PCI primary
bus 0 (PCI slot 5) and restarting the
server.
If the problem persists, go to “General
checkout” on page 8.
– PCI 2 LED on
An error occurred on PCI primary bus 1. An
adapter in PCI slot 1, 2, 3, or 4 or the system
board caused the error.
Actions:
1. Check the error log for additional
information.
2. If you cannot correct the problem
from the information in the error log,
try to determine the failing adapter
by removing one adapter at a time
from PCI primary bus 1 (PCI slots
1–4) and restarting the server after
each adapter is removed.
If the problem persists, go to “General
checkout” on page 8.
– CPU Wrong Slot LED on
The combination of microprocessors and
terminator cards is not valid.
Action: Install the microprocessors in the
correct order. See Table 13 on
page 240.
Netfinity 5500 M20 - Type 8662
49