IBM 866251Y - Netfinity 5500 M20, Hardware Maintenance Manual

Page: 284 / 386

Server door and trim bezels removal
Refer to the following illustration while you perform the
steps in this procedure.
.1/
Server door
.2/
NetBAY3 bezel
.3/
Media-bay trim bezel
To remove the server door:
1. Unlock and open the server door
.1/
.
2. Lift the server door up and off its hinges. Store the
door in a safe place.
To remove the NetBAY3 bezel (tower models only):
1. Unlock the NetBAY3 bezel
.2/
.
2. With your fingers on the ribbed area on the right side
of the NetBAY3 bezel
.2/
, grasp the right side of the
NetBAY3 bezel and pull it away from the pedestal.
3. Unhook the left side of the bezel from the server.
Store the bezel in a safe place.
To remove the media-bay trim bezel:
1. Release the two tabs at the bottom edge of the bezel
.3/
and pull the bottom of the bezel slightly away
from the server.
2. Pull the bezel down to release the two tabs at the top
edge of the bezel. Store the bezel in a safe place.
276
Netfinity Server HMM