IBM 866251Y - Netfinity 5500 M20, Hardware Maintenance Manual

Page: 160 / 386

ipsadm &
3. Press Enter.
Ÿ
If you are using Novell NetWare:
1. Load the remote component. To do this, type:
load ipsadm.nlm
2. Press Enter
Notes
1. To load the NetWare Administration
program with NetWare SFT III installed,
load IPSADM.NLM in the mirrored
server engine. The ServeRAID
adapters and controllers in the primary
and backup servers will appear to the
Administration and Monitoring Program
as if they were in one server.
2. When a rebuild, synchronization, or
logical-drive migration is in process,
you cannot stop the IPSADM.NLM
module by pressing the Esc key. To
stop the module during one of these
operations, you must unload the
IPSADM.NLM module.
ServerRAID background-server
components
This section provides information about background-server
component command-line parameters and logging
messages.
Command-line parameters:
To use the command-line parameters provided in the
background-server components, issue the IPSADM
command in the following format:
IPSADM
parameter 1 parameter 2 parameter 3 etc....
Valid command-line parameters for the background-server
components are as follows:
–? The –? command displays the help for the
valid parameters.
–p:number The –p: number command specifies the port
number that the server will check for client
connections.
The port number is a parameter used in
TCP/IP to distinguish among different
services on a single server. The default for
the server utility programs is port number
1087. You can use this parameter to change
the port number if another service on the
system is using 1087.
152
Netfinity Server HMM