ID61/62 Series Panel - Installation, Commissioning & Configuration Manual
Introduction
2
997-457-000-8, Issue 8
January 2010
1.3 General
The ID61 and ID62 range of fire control panels is designed
for use with NOTIFIER’s range of addressable analogue
sensors, control and monitoring modules and addressable
call points. A unique signalling protocol is used, having
digital address and control signals and analogue pulse
width monitoring for the reply data from devices.
The serial communications interface operates under
RS485 protocol and enables communications between
the fire panel and repeaters.
While every effort is made to ensure the accuracy of the
content of this manual, the manufacturer reserves the
right to change the information without notice.
Installation
The ID61/62 Panel is easy to install providing the
recommended procedures described in this manual are
followed. To avoid inadvertent contamination of the PCB
Assembly, the manufacturer recommends it be installed
in the back box only after all other trades have completed
their tasks.
Commissioning
To commission the ID61/62 Panel, follow the recommended
procedures described in this manual. The manufacturer
recommends that during commissioning and maintenance,
ALL RS485 signal cables are disconnected at the Panel
end, BEFORE powering down the system and are
connected AFTER powering up the system.
Configuration
To configure the panel and system, carefully read and
follow the procedures given in this manual. These
procedures describe the menus that are displayed on
the Liquid Crystal Display (LCD) Unit.
Refer to the ID61/62 Series Operating Manual (ref: 997-
458-000-X) for a description of compatible addressable
Signalling Loop Circuit (SLC) analogue devices.
1.3.1 Date-dependent Functions
The calendar end date for this product is 31/12/2063
(two thousand and sixty three) and it will perform correctly
up to this date.
The calendar function has not been tested beyond
this date.
1.4 CE Marking
CE
This panel is CE Marked to show that it conforms to the
requirements of the following European Community
Directives
Only fit the electronics
module after all the other
trades have completed
their tasks!
Only suitably-qualified
engineers must install,
commission and
configure this product
