Hioki MR8740-50, Instruction Manual

Page: 82 / 238

76
Configuring Generator-Module-Specific Settings
Voltage generation and measurement function
Outputting an AC voltage
The instrument can output a sine wave with a DC voltage superimposed.
DC offset voltage 0.1 V to 2.5 V
Amplitude
0.1 V p-p to 5.0 V p-p
Frequency 10 Hz, 20 Hz, 50 Hz, 100 Hz
CAUTION
The instrument accepts a load resistance of 1 k
Ω
or more. Do not connect a load
resistance lower than the permissible value or short-circuit an output terminal. Damage
to the instrument could result.
IMPORTANT
If you choose a frequency other than the frequencies that can be specified, the instrument sets a
frequency to the one that is the closest.
Output
Switch each output on and off.
OFF  Does not output any waveform.
ON
Outputs a waveform.
Switch
You can switch between the short-circuited state and open state for the OUTPUT terminal.
Open Disconnects the OUTPUT terminal from the output circuit and the GND terminal.
Short Connects the OUTPUT terminal with the GND terminal.
Normal Connects the OUTPUT terminal with the internal output circuit.
Confirmation of the setting
After finishing the setting, click
[Apply]
.
The instrument confirms the settings and outputs a waveform.