Hioki MR8740-50, Instruction Manual

Page: 143 / 238

137
Configuring the Numerical Calculation Settings
3
Click the [Calculation Type] box, and then choose a calculation type from the list.
Off  The instrument does not perform any calculation.
Average value Average value of waveform data
RMS
RMS value of waveform data
P-P Peak-to-peak value of waveform data
Maximum Maximum value of waveform data
Time to maximum Period of time elapsed from a trigger point to the time of the maximum value
Minimum
Minimum value of waveform data
Time to minimum Period of time elapsed from a trigger point to the time of the minimum value
Period *
2
Period of waveform data
Frequency * 2 Frequency of waveform data
Rise time
*
1
Rise time of waveform data
Fall time *
1
Fall time of waveform data
Standard deviation Standard deviation of waveform data
Area Area enclosed by the horizontal axis and waveform data
X-Y area Area enclosed by an X-Y composite curve
Time to level *
2
Period of time elapsed from a trigger point to the time when waveform data
reached the specified level
Level at time * 2 Measured value when the specified time has elapsed from a trigger point
Pulse width *
2
Pulse width of waveform data
Duty ratio *
2
Duty ratio of waveform data
Pulse count *
2
Pulse count of waveform data
Arithmetic operations
Four arithmetic operations of numerical calculation results
Time difference *
2
Time lag between phenomena A and B
Phase contrast *
2
Time lag between phenomena A and B represented as a phase difference
High level *
1
High level of waveform data
Low level
*
1
Low level of waveform data
Intermediate value Intermediate value of waveform data
Amplitude *
1
Amplitude value of waveform data
Overshoot *
1
Overshoot value of waveform data
Undershoot
*
1
Undershoot value of waveform data
+Width *
1
Time value above the intermediate level
−Width *
1
Time value below the intermediate level
Burst width *
2
Burst width of waveform data
Accumulation
Accumulated value of waveform data
Angle of XY waveform Slope angle of a regression line on an X-Y composite curve
*1: Unable to make any calculations using data acquired across the measurement channels of Model MR8990
and Model MR8990 Digital Voltmeter Unit.
*2: The settings can also be configured for the logic channels.
Refer to “Calculation target channels and setting contents of calculation conditions for each calculation type”
(p. 139).
7
Numerical Calculation Function