Hioki MR8740-50, Instruction Manual

Page: 20 / 238

14
Configuring the Input Channel settings
5
Click the [Display] button to set it to [On] or [Off] .
On  Displays the waveform on the waveform screen.
Color
Allows you to choose a waveform display color. You can also choose the
same color as lines acquired across other channels.
Invert
(
Off
 ,
On
)
When the signs of displayed waveforms are reversed, the waveforms can be
inverted.
Refer to “3.4 Inverting a Waveform (Invert Function)” (p. 44).
Vernier Allows you to freely fine-adjust the input voltage on the waveform screen
(display adjustment only). When recording physical values such as noise,
temperature, and acceleration with sensors, you can adjust those amplitudes,
facilitating calibration.
Refer to “3.3 Fine-Adjusting Input Values (Vernier Function)” (p. 43).
Off
Does not display any waveform.
6
Configure the scaling settings.
Refer to “3.2 Converting Input Values (Scaling Function)” (p. 38).
7
Switch the channels.
Click the corresponding location to switch the channels, and then set the measurement conditions by following
the procedure above.