Hioki MR8740-50, Instruction Manual

Page: 59 / 238

53
Configuring Measuring-Module-Specific Settings
9
Click the [Level] box, and then from the list, choose a side of the threshold level to be
detected for pulse width measurement and duty ratio measurement.
Only when [Mode] is set to [Pulse width] or [Duty ratio] , this setting is available.
High  Measures waveforms on the upper side of the threshold level.
Low Measures waveforms on the lower side of the threshold level.
10
Click the [Smoothing] box, and then choose a scaling setting from the list.
Only when [Mode] is set to [Freq] or [Revolution] , this setting is available.
Off  Records measured data without smoothing (resulting in a step-like waveform).
On Interpolates measured data to smooth a waveform and outputs it.
(Upper limit: 10 kHz; outputting data with this setting set to on lags behind that with this
setting set to off)
11
Click the [Hold] box, and then choose a measured-value retaining setting from the list.
Only when [Mode] is set to [Freq] or [Revolution] , this setting is available.
Off (1 Hz)
,
Off (0.5 Hz) ,
Off (0.2 Hz)
,
Off (0.1 Hz)
When the instrument does not determine the measured value even after the frequency
reaches a value in the brackets, the measurement is defined to stop and regards the
measured value to be 0 Hz (0 rpm).
On  Retains the value confirmed the last time.
12
Click [Close] .
The setting dialog box closes.
3
Advanced Functions