HDG M299, Operation Manual

Page: 76 / 176

5 Commissioning the system – Procedure
76
HDG M299/300/350/400 - Version 1 - en
©
HDG Bavaria GmbH 07/2008
A
DAPTING PARAMETERS
The parameters of the HDG Control unit are programmed with the
predefined factory settings upon delivery. The predefined values of
the factory settings are intended for operation with wood chips.
In practice, operators usually have their own heating system
requirements. Differences result from, for example, the sit-specific
requirements or the heating fuel. If the heating system is operated
with wood pellets or chips, the relevant parameters must be
changed.
In all cases, it is necessary to check the predefined parameters and, if
necessary, change them accordingly before commissioning the
system.
Danger!
Material damage and injury due to incorrect settings.
Adjusting these parameters requires comprehensive specialist
knowledge. If the parameters are adjusted by an untrained person,
the heating system can be damaged.
Only allow authorised specialists to make adjustments to the
parameters.