HDG M299, Operation Manual

Page: 59 / 176

4 Planning and installation – Installing the heating system
59
31.Insert suspension rail (O) with the right end in the vertical rail (N)
and fasten it with the M6 hexagon socket screws (5 mm spanner)
and intermediate washer to the vertical rail (N) or the corner
support.
32.Set the vertical rail (Q) in the suspension rails.
33.Set the vertical rail (R) in the suspension rails.
A
LIGNING THE SUSPENSION
RAILS
34.Align the corner support (3) vertically with the aid of a spirit level.
35.Tighten the three M6 hexagon socket screws (5 mm spanner).
36.Align the support rail (1) horizontally using the adjusting screw in
the cladding bracket and a spirit level.
37.Align the corner support (2) vertically with the aid of a spirit level.
38.Tighten the three M6 hexagon socket screws (5 mm spanner).
39.Proceed with the alignment of the suspension rails in the same
manner as described above for the remaining three sides of the
boiler.
I
NSTALLING THE BASE CLADDING
HDG TBZ 200
Figure 4/22 - Aligning the suspension rails
3
1
2
Important!
Adhere to the specified sequence when installing the base
cladding. The sequence is indicated by the numbers with asterisk
(e.g. 1*, 2*, etc.).