has been powered on, it will bring you directly to the initial configuration screen shown below. Note
that the OmniPL uses a resistive touchscreen that is appropriate for a pool environment. It requires a
deliberate push when selecting a button. At the initial configuration screen, touch the Configuration
button in the center of the screen. On the following screen, touch the Configuration Wizard button
as shown below.
About the Configuration Wizard
The OmniPL uses a Configuration Wizard to assist in the configuration of the OmniPL. The Configu-
ration Wizard will ask you general questions relating to your pool/spa and specific questions about
connected pool equipment. Because this process may take some time, do not begin to configure
the OmniPL unless you can dedicate at least 15 minutes or more. Configuring the OmniPL requires
knowledge of all of the connected pool equipment so have the Connection Table (page 16) handy
while configuring the OmniPL.
If you are asked a question and don’t know the answer, in many cases you’ll be able to skip the
question and proceed. In some cases the Configuration Wizard will require an answer. Answer the
question to the best of your ability and take note as you’ll be able to go back into the Configuration
Wizard at a later time to make changes.
Navigation
The Configuration Wizard has been designed to be intuitive allowing most users the ability to navi-
gate with little instruction. Below, a list of commonly used buttons are explained..
Done
- Touch this button to complete your selection.
Cancel
- Touch this button to cancel your selection.
Advance
- Touch this button to advance to the next screen.
Back
- Touch this button to return to the previous screen.
Add
- Touch this button to add an item
Delete
- Touch this button to delete a highlighted item.
SYSTEM
configuration
1 / 2
system info
config wizard
backup config
restore config
display
network
web server
date/time
configuration
No config found
29
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS