Do You Have a Water Temperature Sensor?
Select whether there is a water temperature sensor
wired to the OmniPL.
If Yes is selected:
Where is the Sensor Wired?
Touching the box will bring you to a table showing all detected sensors connections. Se-
lect the sensor connection used for the water sensor (typically SENS1) and touch the Done
button. The sensor connection should now be shown in the box and you can advance to
the next screen to continue configuration.
Do You Have a Flow Switch?
Select whether there is a flow switch wired to the OmniPL.
If Yes is selected:
Where is the Sensor Wired?
Touching the box will bring you to a table showing all detected sensors connections. Se-
lect the sensor connection used for the (typically FLOW SWITCH 1) and touch the Done
button. The sensor connection should now be shown in the box and you can advance to
the next screen to continue configuration.
Select and Configure Sensors
At this screen you can add, delete and configure your sensors.
Select the desired sensor, then touch the Advance button. When finished configuring sensors, you’ll
be returned to this same screen. Touch the Done button and advance to the next section of configu-
ration. Refer to the following information when configuring sensors:
Where is the Sensor Located?
Touch the box and go to the table showing the Bodies of Water
and the Backyard. Select the location where the sensor is installed.
What Type of Sensor?
Select the type of sensor. Choices are Air, Water, Flow or Solar.
Name Sensor -
Touch the box and use the keyboard to name the sensor.
Where is the Sensor Wired?
Touching the box will bring you to a table showing all detected
sensors connections. Select the sensor connection used for the sensor and touch the Done
button. The sensor connection should now be shown in the box and you can advance to the
next screen to continue configuration.
Do You Want to Configure Any Backyard Lights?
Select yes if you are using any type of pool, spa
or outdoor lights. The options are UCL (14V), CL4.0 (115V), CL2.5 (14V), Incandescent, and Other.
Transformers powering Universal ColorLogic lights must all be connected to the same high voltage
relay for synchronization to function properly. If using Omni Direct mode, you must use an internal
relay, not an HLRELAYBANK.
If Yes is selected:
What Kind of Lights?
Touch the box to select the type of lights that will be used. The options
are UCL (14V), CL4.0 (115V), CL2.5 (14V), Incandescent, and Other.
Name the Group of Lights
- Touch the box and use the keyboard to name the lights.
How Many Relays are Lights Wired to?
Select the number of relays used by the lights.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
46
